Assigning Group Codes

Follow

Assigning Group Codes For a Cubit Only(Non-ESW) Jobs:

To assign grouping codes to a job, open the Job in Cubit, and select Edit Columns from the Data tab on the toolbar to look up and assign Group Code/s to a job.


From the list of Group Codes tick the code list to be assigned to the job.
The ability to add more than 1 code list is only in professional version of Cubit.

                          


The code column will then be added to the job. When double clicked it will list the codes for you to pick from.

                    


If needed, You can un-assign/remove the code column from the Edit columns window anytime.

                        

 

 

Assigning Codes for ESW transferred Cubit Jobs:

For ESW jobs the codes needs to be the Q/Q2/R/R2 Constraint.                                                              The Constraint must be applied/verified in the Codes window. Tick on the constraint boxes to apply Q/Q2/R/R2 Constraint accordingly.

              


In case the codes does not meet the requirement then a warning like below is displayed.
Edit the codes to make sure the length of the codes adhere to the Rules.

                


Open the ESW Transferred Job in Cubit and select Edit Columns from the Data tab on the toolbar to look up and assign Group Code/s to a job.

 
From the ESW Group Mapping use the drop box for the list Constraint to select from.

                                      

 

The code column will then be added to the job. When double clicked it will list the codes for you to pick from.

                      

 

 

 

 

 

 

 

 

 

0 out of 0 found this helpful

Comments

2 comments
  • How can I use this feature to install three levels of codes?

    eg.

    Preliminaries is 01

    Company Management is 01.02

    Estimator 01.02.010

  • Hi David

    Thanks for the comment. Will you be needing to export estimate information from Cubit back into the legacy Global Estimating system?  

    If yes, your cost code cannot be any longer than 6 characters. You would need to use 010210 as your cost code instead of 01.02.010

    If you are only going to use Cubit, your cost codes can be up to 25 characters long.

    Global Estimating R2 coding columns can only accept up to 6 characters.

    I hope this helps. 

     

Please sign in to leave a comment.